Intelligently produced radiator heating is not just an energy efficient and sustainable solution. The large surfaces and minimal content of water mean that the temperature is quickly regulated. A rapid adaptation to the environment means lower energy consumption and less CO2, which in the end is a benefit for both the environment and the economy. There is thus also less heat loss than with other heavier heat sources. At the same time, our radiator design is timeless. This means, among other things, that even though current trends, tendencies and fashion can lead to changes in the building's interior design and colors on the walls - the Hudevad radiators remain a timeless Danish design that always fits into the building.
Steel is without a doubt a "heavy" metal to extract, but that does not necessarily mean that the material is bad for the environment and our planet. Once the steel is extracted, it can be recycled over and over again with the use of very few resources without leaving the sustainable cycle. This means that the steel does not disappear and can be reused again and again in the future without losing its properties
Steel is the main component in most of our radiators and gives Hudevad products a long life cycle. Durability ensures that even in busy and exposed environments, the radiators and their design remain intact. Often, our radiators last even longer than the actual building in which they are installed and rarely need to be replaced throughout the lifetime of the building.
In addition, we are constantly trying to improve and optimize our products to save on our resources and reduce our production waste. It can be through a new design that uses thinner steel plates or re-design of a radiator so that it can be produced with less energy consumption. That way, we save on our production budget, and we reduce our consumption of new resources.
Even with the long durability and lifespan of our radiators, all of our radiators can be 100% recycled after use and remelted into new radiators or completely new products. This - e.g. by returning the products to our factory so they can be included in new radiator designs - can save our atmosphere from further Co2 impact.
All surplus material from our factories, e.g. clippings and punched-out pieces, are collected, sorted and recycled. The material parts that are not part of the finished product therefore become part of our steel's "circle of life" and can end up at the factory again as "new" material, ready for use in production again.
Most countries today are very good at recycling steel and we therefore recommend that you do not transport the radiators unnecessarily far after use, as this can have a negative effect on the product's environmental footprint.
If you need help with a project, have a technical question you can't find the answer to or do you need more information before choosing a radiator - then feel free to contact us.
